6" VORTEX DOUBLE WALL TELESCOPING SECTION (40"-68") VOD0056

While there is no strict limitation on total length except as stipulated in NFPA 211 (USA) or CSA B365 (Canada), the manufacturer recommends a maximum of 15 feet if there is an offset in the installation. Without any offset, do not exceed 20 feet of total double wall stove pipe length. All sections must be solidly fastened together and properly supported according to installation guidelines.

No, you should only use Vortex Double Wall connector pipe and listed components together. Do not mix with other manufacturers' products or with single wall stove pipe. Mixing different brands or types can compromise safety, void warranties, and may not meet required safety certifications. Always verify compatibility before purchasing additional components.

Have your connector pipe and chimney professionally cleaned by a certified chimney sweep at least annually or more frequently with heavy use. Use only plastic-bristle, wood, or flexible steel brushes for cleaning - never use chemical chimney cleaners as they can accelerate corrosion. After any chimney fire, have the system inspected and approved by a professional before reuse.

This double wall telescoping section requires 6 inches clearance to combustible side walls and 8 inches clearance to combustible ceilings. For non-combustible materials like brick or cement, clearance can be 0 inches, though pipes should not actually touch these surfaces. Always maintain the minimum clearances specified by your appliance manufacturer as well.

The limited lifetime warranty applies only to the original purchaser and is non-transferable. It covers replacement of defective double wall pipe components free from manufacturing defects when properly installed, maintained, and used. The warranty does not cover damage from improper installation, chemical cleaners, burning prohibited materials, or normal wear and tear. Labor and installation costs are not included.

Yes, this telescoping section can be installed horizontally between elbows and adapters when connecting your stove to a chimney system. When installing horizontally, use at least three #8 X 1/2" self-drilling screws at each pipe joint and use pipe hangers as needed to provide proper support and prevent sagging over time.

Vortex Double Wall connector pipe is designed to connect solid fuel fired appliances to factory-built insulated chimneys or properly relined masonry chimneys. It is compatible with various brands including Ventis, Champion, and Nexvent systems. Verify that your chimney system is properly sized (6" diameter) and meets current safety standards before connecting this double wall pipe.

If a chimney fire occurs, immediately contact your local Fire Department. Do not use the appliance again until the entire system - including the chimney, connector pipe, and stove - has been thoroughly inspected by a professional chimney sweep and/or Fire Department Inspector. The pipe and chimney must be approved for safe operation before resuming use to prevent further dangerous incidents.